|Minimum Order Quantity||1 Set|
Our clients can get a wide range of Mechanical Shiftless Mill Roll Stands from our organization.
|Primary Exchanger Material||ALL|
The double facers offered by us are used to make perfectly bonded board. The liners are heated and transported to the double facer free of stress due to the pre-conditioner. The hot plates stay completely flat for steady heat transfer over the entire working width without edge crush in all operating conditions. Different numbers of hot plates can be configured in heating section according to requirements of our clients. Further, the pressure rolls of cooling section make sure perfect forming quality. The specially designed feed geometry aid in eliminating bubbles & ripples in the liner and conditions it prior to bonding. Designed to have low friction properties, these facers are highly corrosion resistant.
Flow of steam/oil within the Hot Plates ensures even heat transfer across the full surface and minimum loss of energy
Pressure rolls can be adjusted in micron individually depending upon the grade of board & speed of production
The upper and lower Double Facer Belts are synthetic
The belt is mechanically or pneumatically lifted from the hotplates when the machine stops
Rubberized /M.S. Puller Rolls are used
The upper and lower belt drums are driven by synchronizing with cut-off
The drive rolls are wrapped with double helically grooved rubber, in order to increase the traction of belts
|Capacity (ton/day)||30-40, >40|
|Output Paper Width||0-500 mm, 500-1000 mm, 1000-1500 mm, 1500-2000 mm, >2000 mm|
|Speed||0-50 meters/min, 50-100 meters/min, 100-150 meters/min|
|Design speed||200min 250min|
|Can store||999 groups|
|Minimum Order Quantity||1 Unit|
◆ Can store 999 groups of orders,achieve non-stop machine changing order automatic or manual.
◆ Slitting knife and creasing wheel with servo control any single row, single row fast, accurately.
◆ Front and behind two rows of the creasing wheel configuration, creasing wheel in any combination to achieve zero-pressure line.
◆Automatic tracking production line speed to ensure synchronized,also can connect with the production management system, strong compatibility.
◆ From high-quality imported industrial computers and high-performance programmable controller constitute machine computer control system
◆computer-controlled automatic or manual knife sharpener, knife sharpen while working to improve productivity
|Max. design speed||150 m/min|
|Effective width||1400 mm to 2500 mm|
|Length of cutting cardboard||500- 9999 mm|
|Max design speed Straight knives||120 m/min, Helical knives 150 m/min|
|Width||1400 mm to 2500 mm|
A short diameter of knife shaft, high average speed better to improve the productivity
Exact and adjustable no gap gear assure knife-edge joggle exactly
NC. reserve groups of order, and auto-complete as the procedure or according as preferential condition, the screen display various production message
|After Sales Service available||Yes|